Quick Answer: Can You Over Power Subwoofers?

What subwoofer has the deepest bass?

Below are the top 10 best car subwoofers for deep bass that we recommend to help you get started.1) JL Audio 12W7AE-3 12″ Subwoofer.2) Orion HCCA12 12″ Subwoofer.3) MTX Audio Terminator TNE212D Dual 12″ Subwoofers.4) Rockford Fosgate P300-12 Subwoofer.5) JL Audio 10TW3-D4 10″ Shallow Mount Subwoofer.More items…•.

Can a subwoofer break glass?

Breaking house-windows should be possible, but will also need a lot of subwoofers because the room is larger than a car but the glass is not as strong.

Is it bad to Underpower a subwoofer?

Underpowering a subwoofer isn’t inherently bad for the sub. Not giving it enough power just means that the music will sound weak and lack detail. The danger is when that power is coming from an amplifier that’s being overworked and sending out a clipped signal.

What hits harder 1ohm or 4ohm?

Technically speaking, a subwoofer rated at 1-ohm impedance load will hit harder and produce more output than a 4-ohm subwoofer, given similar input wattage, because the resistance is much lower.

Is it better to overpower or Underpower a subwoofer?

It’s better to overpower a speaker than to underpower it — the distortion caused when you push a low-powered amp or receiver to its limit is much more likely to harm a speaker than too much power.

What is the hardest hitting subwoofer?

Rockford Fosgate P3D2Rockford Fosgate P3D2 10-inch Subwoofer Boasting 500 watts of continuous power handling and 1000 watts of peak power capacity, this is the hardest hitting 10-inch subwoofer in our comparison.

Do subwoofers get louder as they break in?

No, that’s normal, especially subs with stiff suspensions. Once they loosen up, they will play louder and sound better.

How long should I break in my subwoofer?

Once the system is up and running with your break-in cut, run it at moderate volume for around 15 minutes or so. This allows everything in the amplifier and driver time to adjust and begin warming up. This is an often-overlooked phase of break-in.

What hits harder 10s or 12s?

But, generally speaking, given adequate power the two 10″ subs will sound a little cleaner and punch harder because their combined cone surface area yields more sound pressure. The single 12″ sub, however, may sound a little deeper.”

How many RMS is 1000 watts?

In fact, most amplifiers labeled as 1000 watts PMPO have a true RMS output of 10 watts or less. One that I measured put out 7.5 watts per channel. So, like I said…

Is more watts better for subwoofers?

More bass does not necessarily mean better bass. The power is determined by the wattage of the subwoofer in question, where a higher wattage demonstrates a more powerful subwoofer. … Just remember: A 500-watt subwoofer doesn’t necessarily mean it has to be played five times louder than a 100-watt subwoofer.

Is too much air space bad for subwoofers?

No, it will in fact increase output. A larger air space means more air to compress inside the box as the cone moves, which means less resistance on the cone, which means more cone movement allowed, which means more output (whew).

Why do my subwoofers smell?

New subs can get a little stinky if you get at them, there’s often bits of excess glue burning off. … There is only one reason that subs smell and that is because the voice coil glue is getting hot and ‘off-gassing’. This is the only reason subs smell bad.

Is it normal for subs to get warm?

But if your running your amp in less than a 4 ohm load you will be pushing more power and its causing your coils to get too warm. this would be why your subs are heating up. but if you have a 4 ohm load, then it would most likely be from clipping.

How much airspace does a 15 subwoofer need?

10 inch drivers: 1.0 to 1.5 cubic feet. 12 inch drivers: 2.0 to 3.0 cubic feet. 15 inch drivers: 5.0 to 9.0 cubic feet.

How many watts is a good subwoofer?

If you have: A factory radio — you won’t need more than 50 to 200 watts RMS of power for the bass. An aftermarket receiver — you might want 200 to 300 watts RMS of power. Amplified speakers with around 50 watts RMS per channel — 250 to 500 watts RMS is a good starting point.

How long should a subwoofer last?

There are a lot of variables that will impact how long your equipment lasts, but in general a good sub can last for 20+ years.

How do I make my subs hit the hardest?

How to Make Subwoofers Hit HarderChoose the correct amplifier for the subwoofer. Every type of subwoofer requires a certain power output by an amplifier. … Install the subwoofer in a bandpass box. … Adjust the settings on the amplifier and stereo unit to accommodate the subwoofer.

What happens if a subwoofer box is too big?

Remember, there is such a thing as too big. As the size of the enclosure increases, the mechanical limits of the woofer will be easier to reach. If the box is too small (by a reasonable amount) add power. … If the port becomes too small, it may result in port noise, or allow the woofer to simply unload.

What phase should I set my subwoofer?

A: Depending on the absolute phase of your main speakers and amplifier and the distances of the subwoofer and the main speakers from the listening position, the bass in the crossover region may be smoother if you reverse the subwoofer’s phase. Typically, though, phase is left at 0° for most applications.